BA1204 Beam Shutter / Bi-positional Actuator

Item No.: BA1204
Beam Shutter / Bi-positional Actuator

BA1204 Bi-positional Actuator

The Bi-positional Actuator BA1204 consists of two fast and reliable actuators for variable application. The short setting time of 25ms enable the actuator to cycle up to 20 tims each second. Due to the mass inertia of the actuator arm, 18 cycles per second are assumed realistic.
The ultra compact SMD-board driver is mounted on the rear end of the actuator. The board only needs an external supply voltage of 12 - 15VDC at 250mA. The buffered signal input of the actuator works with a voltage 4 - 25VDC. A current free circuit enables the user to run the actuator with TTL or CMOS devices.

Specifications:
  • The BA1204 is equipped with a glued dielectric mirror, which endures up to 15 Watts optical power.
  • You may mount the BA1204 on the optical table using the 5.5mm hole on the sub-panel. The BA1204 is now ready to switch the beam horizontally at an angle of 90°.
  • All parts are assembled and tested. DO NOT remove the arm from the shaft, the setup might be mis-adjusted.
  • The BA1204 are shipped with a special transport safety. Please following the instructions carefully:
  • Mirror size: 12.5 x 12.5 mm.
  • Size: 42 x 42 x 60 mm.
  • Unit Price: $99.00 (with mirror).
  • Unit Price: $89.00 (without mirror).
  • Quantity discount prices are available.

    Prices are FOB Minden, USA and subject to change without notice.
    The specifications are subject to change without notice.


    What's New |  Hot Buy's |  Quotation |  Place Order |  About Us |  Legal

    © 1996 - 2011 MeshTel - INTELITE INC.